Canon Speedlite 199A User manual

Se Aa | ee ee |
Attachment groove for Wide Adapter 199A

1. An electric signal from the 199A conveys
«the f/stop selected on the 199A to the
camera side and automatically sets the
f/stop on the camera except AV-1.
2, In the same way, the light output signal
from the 199A ‘automatically sets the  «
shutter speed of the camera to 1/60 sec.

X contact).
8. Shutter speed settings of 1/30 sec. or
below and B can be used with the A-L ‘

4. Battery consumption is reduced with
the employment of the series control
system.

5. The 199A may be used jointly with the
Power Winder A or Motor Drive MA.

6. Average distribution of metering is
obtained by suppressing the peak sensi-
tivity at the center of the picture.

2. Stabilized exposure is obtained with the

‘in regulator circuit.

a. Thecpilot lamp lights p to indicate that
firing of flash is possible and flashes on
and off to indicate that the condenser is
fully charged.

9. The 199A has a built-in flash confidence

it.
10, The fash firing section tilts up to 90°
Thus, bouncing of flash is possible with
the 199A attached to the camera. ‘
11, By setting the main switch at OFF,

agape! automatic fash settings cease operat
rita cova Codi tg SORE and the camera returns to the norma
a SS non-flash AE control while the 199A

Wide Adapter 199A still attached to the camera.

12. The flash angle of coverage is desi
for the field of a oeeraiees ith ne
of the Wide Adapter for 199A.

Fold out both front and back nomenclature pages
for easy reference while reading the instructions.