Mamiya M645 Super - Quick Setup User manual

www.orphancameras.com



 Uniquelydesignedto preventerrors,the M645 Super incorporates
 numeroussafety features, so if you can not release the shutter,or
 removea lensor holder,it is most likelydue to usererror ratherthan
 a camera malfunction.Should somethingappear to go wrong, be
 sure to check the followingpoints.

 The Shutter Release Button  does not depress.
 o Has the ShutterReleaseSelectorbeen set to the n mark?
 o Does the BatteryCheck Lamp light up? (lf it doesn't,replacethe
    battery.)
 o Has the Wind-upCrank been turned until it stops?
 o Has the Dark Slide of the Roll Film Holderbeen removed?
 The Mirror  is locked  in the up position.
 o Has the MirrorLock-upLever been set to "M.UP tr"?
 The developed  roll tilm has 1 or 2 frames  less than   it
 should have.
 o Did you properlyalignthe start marksof the film and the Roll Film
  lnsert?
 The Film Holder can not be removed.
  o Has the Dark Slide been insertedinto the Film Holder?
 Gare of the Camera
  * Never touch the ShutterCurtainor Mirror.lf they need cleaning,
    please use a hand blower and soft tissue paper or a feather.
  * Do not leavethe camerain the MirrorLock-upcondition.This will
    avoid burningof the ShutterCurtainby direct sunshine.Please
    always returnthe Mirrorto normalpositionor put a Lens Cap on
    the Lens.
  * Do not remove the safety cover of the Flash Synchro Terminal
    exceptwhen usingflash.
  * The ElectricContactsof the camera and accessoriesshould be
    kept clean.





"Pdaroid'  b c r€dseredtdcrmflr       ot Fdatoid                            U.SA

1645SUPERAGGESSORYSYSTEMwww.orphancameras.com





 Removing  the Lens
 The lens is removed in the
 same manner as the front
 body cap.

www.orphancameras.com



AN INSTANT
OPERATION
MANUAL                 Remove the  Battery Chamber    Insert the battery.                    Battery Check
                                     Cover                        Make sure battery @ and Q marks   Push the BatteryCheck Buttonand
                                     by sliding the Locking Latch in the    are properlyaligned.               check for illuminationof the Batterv                                            directionof the arrow.                                                                                            Check Lamp.





  Place the film in the Film Insert.     Feed the leader paper to the Take-    Align the start mark.             Open the Back Cover of the Roll
                                 up Spool by pullingthe leaderpaper    Rotate the Take-up Spool in the    Film Holder.
                                       gently as shown in the diagram.    directionof the arrow, and align the    Hold down ButtonQ in the direction
                               Then insed the tip into the slot of the     film stad mark with the mark on the    of the arrow and press Button@.
                                 Take-upSpool.                   SpoolClip.

www.orphancameras.com





  Remove the Dark Slide.            Set the Multiple Exposure Lever    Turn the Wind-up Crank.           Releasethe shutter.
   Store it in the Dark Slide Slot.        Set Lever to "MULTI  " for multiple  Turn the Wind-upCrankuntilit stops.   Set the Shutter ReleaseSelectorto
                                  exposure capability.(MultipleExpo-  (When using Power Drive, set the   the "!"  mark,and pressthe Shutter
                                     sure Lever of Power Drive is located   Lever "START".)                 ReleaseButton.
                                on the bottomof Power Drive.)





Insertion of the Film Insert          Set the Multiple Exposure Lever to    Wind the film                       Set the correct film speed value
Insertthe Film Insert into the Roll    "n" mark (Single exposure).        Turn the Wind-upCrankuntilit stops.   on the Film Speed Dial.                                                           The ExposureCounterwill be set toFilm Holderas shown.                                                                                 1. (ln case of PowerDrive,the Expo-
                                                                  sure Counterwill be set to 1 auto-
                                                                         maticallyby setting the Operating
                                                                          Indicatorto "START").

www.orphancameras.com





Check of A.M Lever.              Opening the Waist Level Finder N    Focusing                     The RangefinderSpot will be very
The A.M Lever must be set to "A".     Pullup on O to openthe finder.Push   Adjustthe FocusingRing for a sharp   usefulfor focusingas shown.
                 @ in the directionof the arrow so that   and clear image.
                                   the Magnifierraises.





To release the shutter, hold the   Turn the Wind-up Crank until  ii   15 exposuresfor 120 film and 30   Unloading the film
camerasteadlyand pressthe Shutter  stops.                           exposures tor 22O film will be avail-   After the fixed number of exposures
 ReleaseButtongently.                                                    able.                           has been taken, wind the film by
                                                                                                              turning the Wind-up Crank until it
                                                                                                             turns freely.