SEDIC PR-60 User manual

www.butkus.us
INSTRUCTIONS FOR USE:

fnserting battery:
1. Remove the battery compartment cover (l) and insert the mercury battery (Plus mark
    outside) - - 1.3 volt Mallory PX 13 - - into the compartment. Replace the cove firmly.
   The cover can be screwed out and in with a coin.
2. When the meter is not in regular use it is advisable to remove the battery as this prevents
   accidental switching on of the meter. However, the battery should not need rcplacement
   for at least one year.                                                   h           -
Setting the film speed:
   Set the ASA speed of your film in ASA speed window (2) or DIN speed in DIN speed
   window (3) by rotating the  f ilm speed dial (4) using the  f ilm speed dial knob (5).
Using the meter:
1. Take the exposure meter and set the H-L indicator spot (7) at H-mark (6) by rotatrng
   the switch dial (8) if the subject is in bright light, or if the subject is in subdued light,
   at L-mark (9). The H-mark setting is for use in normal lighting conditions and the L-
   mark setting is for rooms and when the light is poor.

Venmo @mike-butkus-camera  Ph. 2083
PayPal Name  Lynn@butkus.org      www.PayPal.me/lynnbutkus

2. When the switch dial is set at H or L- mark, the needle (10) moves anc points a line of
          the guid lines (11). Set the H arrow (12) at the end of the line where the needle stops
        by rotating the main dial (16) when the H mark (6) is at the position, or set L  arrow
          (13) at the end of the line when the L-mark (9) is at the position. The accurate combi-
           nation of shutter speeds and aperture settings (F-stops) can be obtained on the shutter
          speed scale (14) and the f-stop scale (15).                                                                                      \            3.  When using the meter with a cine camera the correct combinatlbn                                                              of f-stops and cine
             f.p.s. (f ilming speed) can be obtarned on the cine  f .p. s. speed scale (17) anO f-stop scale
        {15).                                                              I                                         .                                         /-\                                                                                                                                    l_--'   4.   lf the H-L indicator sopt                O                                                                                               ou.r, the                                             is set at the L-mark (9) and the needle cor.rl
           last line of the guide lines, reset the H-L indicator spot at H-mark.
           5. When the meter is not in use, be sure the switch dial is set at the Off-mark (18).
          6. When measuring the exposure of the subject be careful not to cover the CdS window(2l)
                          off and the needle does not stop at the zero mark (zo), correct the
.       '!f;Y,il1'1,i,?il';,needle position by rotating zero adjusting screw (19) with a small screw driver.
 F
-.r'
                                                                                                                                                                                            n*:                 PRINTED IN JAPAN        .*
                                                                     F*r*-        rI             2      -+'"