ZERO2000 pinhole User manual

www.butkus.us
       Z,e'Ro2ooo
         9
    Thanks for purchaing the Zero Image wooilen pinhole cqrnerd Zero2ooo.
       With Zero 2O0O, the creativity of photography willbe unlimited.
                      Zero 2OOO catnerd is easy to use,
        "  read this manualbefore your first shot for best results.

               NOMENcLATURE
                                                         'I
                                                               A. Shutter
                                                           B. Top cover
                                                                                                                                                                                                                                                                                                                                                 '                                                                 ,C. Top cover lock
                                                                D.Film.wiriding knob
                                                               E. Lens
                                  E Film countei
                                                     G. Exposure guide
                                                                                                                        - H.Back cover
                                                                             I. Tripod socket
                   ,LOaoIxG'FILM

    1. Tum the top cover lock (C) counter-clockwise  to open the top

   2. Slide out the back cover (H).
   3. Insert the tongue of the backing paper of a fresh roll film into
       the slot of the take-up spool.
   4. Insert the fresh film and pick-up spool into the'camera with the
       fresh film at the right-hand side of the camera
   5. Slide back the back cover (H), the film counter (F) should be at
       the left hand side of the camera.
' 6 Cover the top cover (B), adlust the film winding knob (D) so as
            it can insert into the slot (on top of the spool), then tum the
       top cover lock (C) clockwise to lock the cover. Don't be too
        tight or you may damage the thread of the camera.
   7. Tirm the film winding knob (D) clockwise* untilnumber "l"  is
       -displayed in the frame counter (F).
 . 8. For the next frame, simply tum the film winding knob again
    '    until the next number is displayed. Remember to advance the
       film after every exposure.
   9. After the last film is exposured, tum the film winding knob (D)       to wind the remaining film onto the take.up spool. w
     10. Open the top cover and remove the exposed roll of film.

   *Tlw meclwism Vevent you frun unn ttw filn windingknob counter-
     clackwise so di to prevent tlv film fwn aning back  . If you farce n do
     that you will danage he cayra.                                                                                              t

Zg'no2ooo         9
                 ExposuRe
 L Mount the camera to a tripod to avoid fuzzy image.
  aL. To expbse, simply slide the shutter to right, slide it back tb cover the lens when finish expose.
 3. For outdoor bright sun light, the expoiure time is 2 sec.
 4. To calculate the actual exposure time, take a light meter reading with a hand held light meter
    or with a 35mm camera, set the indicated shutter speed by rotate the dial of the exposure
    guide (G) read the exposure time for F/no. 138, then calculate and adjust for reciprociry failure.

 Short.cut to reciprocity co?rections   :
 lUhen the exposure time is 2-4 sec. multiply  it by 2
 \7hen the exposure time is 4-10 sec, multiply  it by 5
 When the exposure iime is 50 sec or over, multiply  it by 12

                 MaIxreNANcE
 L If the shutter or the exposure guide getting loose, fasten the screw lightly with a screw driver.
 2. The mechanism of the film winding knob prevent you from turning the film winding
   knob (D) counter-clockwise so as to prevent the film from curing back. If you force to do that
   you will damage the camera.
 3. Do not clean the camera with alcohol base cleaning agent,it will damage the body of the
    camera. A polishing  oil like lemon oil or orange oil is preferable.

                  SpecrprcATroNs
 Material: \Uood, bpass                                     Pinhole size:0.0079" (0.2mm)
. Size : 5 l/4' (\(/) x3 U4" (H) x 1 3/4' (D)                   Image Circle  : 3.44" (8?.5mm)
 \Teight: llb (250g)                                            Flno.  : 138
 Focal Length  ; 1" (25mm)                                  Tripod Socket : U4" Thread
 Film format  : 120 roll film

                  Specifications and desigtr are subiect to change without notice
                 6'*r
                                     Zero Image Co.
                         Unit 902, \Torkingview Commercial Bldg.,
                          2l Yiu lUa Street, Causeway Bay, Hong Kong
                              Tel: (852) 29499332 Fax: (852) 2465 4492
                    Web Site: http://www.zeroimage.eom
                                        Etnail: order@zeroimage.com



                          @ Copyright Zero Image Co., 2009