Kodak Royal X Pan User manual

New Section

REVISED 1-78

KODAK ROYAL-X Pan Fitm

This is an extremely fast, medium-grain; panchromatic roll film.
Itis recommended for night sports-action photographs by existing
illumination, action photography when the light level is very low,
interior scenes where the shortest possible exposures are needed,
and any other situations where very high emulsion speed is essential.

Handling: Because of the extreme speed of this film, never load
‘or unload the camera in bright light.
‘Total darkness is required for darkroom handling.

Note: This film requires special processing techniques. Only the
developers shown on this sheet are recommended. Ifa photofinisher
processes this film, make sure the special processing service required
tan be provided.

EXPOSURE « Speed ASA 1250

For very flatly lighted subjects, good negatives can be obtained
using meter settings of up to ASA 2000 with normal development,
ind ASA 4000 if recommended development times are increased
by about 50 percent.

Suggested Exposure Settings:

Lighting Conditions ssunject Normat | "Extended
‘Development’ | Development

Baiting Light

‘Bulg tnteriors—courtrooms

‘to 8Tootcandies incident 190 94 1/30 —158
Sports arenas

"ito 01 footcandles incident ans 115-758
Work areas-—store interiors

"$8 BE footcandies incident 15758 wis

tuto" 1600 footeandles incident | 1/125—f722 vias— ps2
eight or hazy sunlight
‘Son to 1o/h0 footeandtes
indent 1300/82
Pasnoatbs
‘i synchronization: 1/500
No sor 35 | yx —sorecr | 711-50 feet
No. Por? | Pacsofeet | 71850 feet

<egien: Since dasibulbe may shatter when fashod, use a flashguard over the
[Reet Do not ash bulbs in a explonive atmosphere

Electronic Flash Guide Numbers: To obtain the lens opening for
electronic flash, divide the guide number by the distance (in feet)
from flash to subject.

OEE em, [5 [0 [190 [oe] ane | 2 [sw son
Guide Number for Trial | 180 [250 | 350 [300 [ 350 | «20 | S00 | 600

Filter Factors: Multiply normal exposure by filter factor given below.

7 “Konax Wears Filter
Light Source [=p wats | Neos | Now? [Nose
Davtigne 2 25 3 5 =
Tungsten a 2 3 2 8

Reciprocity Effect Adjustments:

Use Ei
Indicates
Exposure Time This Lens ‘This Adjusted
TS Seconds) ‘Aperture, Or Exposure Time
jastment "Second
Tao Rone No Adjustment
1am Rome No Adjustment
10 None No Adjustment
1 + Top 2
io 2 Nope 3b
00 3 Hope 100

PROCESSING PROCEDURE ¢ Wii agitation, develop, rinse,
and fix at 65 to 75°F (18 to 24°C). (Note: A slight fog density

is normal.)

1. Develop (Suggested Time in Minutes*):

Exitation st (hgitation at
Koon Second Sime
packaged | __Intervala) Intervals
vvsloners Vice | ance [T0-F] 72°F | Paee||os° [eave [70°F
$e | fore |a1ec | °C | 24°C |] tw°e | Sore | 21-c
foruion | 10 | ¢ fs | a | om la fro fs | se
Parvpor 8 |e | be | 1 Sh oe |u| |e
Be {5 ] 8 | ay | ae foe] SF] Sy | oe
ition af 6 | sf axfae fan 7 fe fo | | aw

Twit properly exposed fim. These suggested developing times should yield nega
tive contfast suitable for panting with a difucon enlarger oF by comtact. For
printing with a condenser enlarger a tower contrast (achieved by a red
Peetdopment ime) is usually desirabie. For complete information about
Entra forte, see Kodak Publication No, F:3, RODAK Professional Black
uae Pm

1Beclopment tines of less than 5 minutes in @ large tank may produce poor
oan uid be ave

wi developers tay produce a deposit of dichroic

Ue fea developers. Exhau
i ‘the film is still wet

Tow The Gepost cam'sometimes be swaboed off hl

‘Bo not use Kooax Developer DI-20 or other developers containing silver halide
nivent, such av thiocyanates or Uniowuifates

2, Rinse: Konak Indicator Stop Bath—30 seconds to 1 minute or
Konak Stop Bath SB-5—30 seconds to.1-minute. Use constant

agitation: Drain the fil for Zo J seconds before immersing it in
the fixer. Note: This step is important. The use of an acid stop
bath minimizes the tendency for dichroic stain deposits on the film.
surface.

3. Fix: Kopax Fixer—5 to 10 minutes or Konak Fixing Bath F-3—9
to 10 minutes or Kopax Rapid Fixer—3 to 5 minutes

4. Wash: For 20 to 30 minutes in running water at 65 to 75°F
(18 to 24°C). To minimize drying marks, treat in Kopax Puoto-FLo
Solution after washing. To save time and conserve water, use KoDak
Hypo Glearing Agent.

5. Dry.

Storage: Keep the unopened package

h cool place [70°F (21°C)
or lower)

‘The Kodak materials described in this publication for use with
Kopak Rovat-X Pan Film are available from those dealers
normally supplying Kodak materials. Equivalent materials may
be used if desired.

Read This Notice: This film will be replaced if defective in manufac-
ture, labeling, or packaging. Except for such replacement, the sale
for any subsequent handling of this film is without warranty or
Habilty eventhough defect, damage, o loss i caused by negligence

EASTMAN KODAK COMPANY, Rochester, N.Y. 14650

Po 624964 1-78 Printed in the United States of America

Kodak, Royal-X, Wratten Polydol, K-50, HC-110, nd Photo-Flo ae trademarc.