Multi-Dedicated TZ250 flash User manual

-DedicatedMulti         Flash
Tz25O




INSTRUCTIONS
MODED'EMPLOI
GEBRAUCHSANWEISUNG
INSTRUCCIONES

Dedicatedfor CANON, NIKON, RICOH
MINOLTA, OLYMPUSand PENTAX CAMERAS
                                www.orphancameras.com

Parts ldentification (Fig. 1l
 1) Zoom/Bounce f lash head
 2l  Select switch
 3)  Battery cover
 4l  AutolManual selectswitch
 5) Sensor
 6)  Mounting shoe
 7l  Turning wheel
 8) Zoom head position indicator
 9) Bounce angle indicator
10) Exposuretable
1 1 )  Auto test lamp
121 On lOtt switch
13) Ready lamp
14I- Test button
15) Wide anglediffuser
16) Synchro cord

                                                                                                   Fig. 1
                                                 www.orphancameras.com                              1

APERTURES AND DISTANCES FOR AUTO.        2l By sliding the bottom scale, set the switch to
MAT|C OPERATION  (Fig. 9)                           the focal length of camera lens (28, 35, 50
The flash unit has two automatic operation               or 85mm).
settings designated by the colors red and blue'       3) Set switch (4) on the front of the flash body
The shooting distance depends on the zoom               to the red or blue Position.
position of the flash head. The red setting is for       4l Set the aperture of the camera to the corres-
strooting at distanqesof up to 20 feet {6 meters)        ponding F stop indicated by the blue or red
 attl4 ASA lOO/DIN 21 at wide position' For           arrows on the guide table. lf flash photos are
longer distances,use the setting which allows           then taken within the indicated distance
shooting up to 30 feet {9 meters} at f2.8 (ASA          (corresponding to the red or blue lines above
1OO/DIN 21 at wide Position).                          the meters/feet scale) correct exposures wi ll
When using the zoom head your automatic            be obtained in almost every situation.
 operating distancescan be increased. For infor-       5) When using bounce at longer range it is often
 -aiion on this pleasesee guide table P. 12).            worthwhile to check the exposure by firing'
                                                       the f lash gun using the Test button, if the
 Using the Y.ride table:                                "Auto Check" light glows the exposure will
 1) By sliding the top scale in the exposure table,       be correct.
    set the scale to the position corresponding to
    the ASA/DIN rating of the film in the camera'
                              www.orphancameras.com
ET                                      :.ra@i,.         l&t                              ;:*i6,&{ga;!;,r, '.dlq,                     .-*ui6de

NOTES ON AUTOMATIC OPERATION
    1) When shooting outdoors in day light, intense
       illumination may cause the computer and
       the auto check lamp to malfunction,  in
      such casesit may be advisable to use manual
       setting.
    2l  After the Ready Light glows always wait for
      a few seconds before making an exposure,
      as sometimes the flash gun may not be fully
      charged.





                                   www.orphancameras.comII;

BOUNCE PHOTOGRAPHY {Fig. 12}
                                            The convenience of automatic operation can
                                              be applied to photography which involves
                                                "bouncing" the light off a ceiling or other
                                                           reflective surfaces to obtain soft illumination.
                                            The flash head has variable positions from 0o to
                                             90o with click stops at every 150.





                                      Fig.12
n4                           www.orphancameras.com

DEDICATED INSTRUCTION
  To set the Select switch (2) to the right position
   to use with your camera:-
   Position "Sl' for cameraswithout dedicated
     f unction
-  Position "O"  for Olympus cameras
]  Position "M"  for Minolta cameras
   Position "N"  for Nikon camerasand Ricoh cameras.
   Position "C"  tot Canon cameras
   Position "P"  lor Pentax Cameras
  When the Ready lamp goes "on,,, this dedicated
   flash will automatically set the shutter speed
   of camera to 1/60 second or "x,'synchro
   settingand have indicating signal inside camera,s
  viewfinder.
I


                                   www.orphancameras.com
                                                                                                                                                        i*.;8

SPECIFICATION

 Guide No.   25 ASA 100 DIN 21 in meter (N 35mm position)
             40 ASA  25 DIN 15 in feet   (N 35mm position)

             30 ASA'100 DIN 21 in meter (S 50mm position)
             50 ASA  25 DIN 15 in feet   (S 50mm position)

             34 ASA 100 DIN 21 in meter (T 85mm position)
             56 ASA  25 DIN 15 in feet   (T 85mm position)

Angleof Coverage: N 35mm position  60l x +Si
              S 50mm position  +61 x 3+l
               T 85mm position  32ox 23o


rE                           www.orphancameras.com