Greist Top Clamp Attachments in Steel Box (original scan) — User manual

SHIRRING SLIDE.                 UNDER BRAIDER GUIDE AND FOOT.





              FOUR SIZES OF HEMMERS.                                                     BINDER.





  DIRECTIONS FOR VEING

             -OUR-
  NEW STEEL SET
             OF
ATTACHMENTS

HOW TO USE THE RUFFLER.
    Remove the regular foot, and slip the ruler in its place with the forks of the lever
  A over the shank of the needle set screw ad fasten securely.          goods to be
  ruffled between the steel blades F. To mak scant ruffling, raise the adjusting block C
        RUFFLER.          by turrg the thumb screw B, and shorten the
                                      stitch to the desired length.-The length ofstitch
                                 shold natch the size of gather or plait, so that they
                                      will lie even and not pile up oneach other or be too
                                           To make larger plaits, lowerthe block
                                   O rad fligthen the stitch to match.  If the ruffle is
                                       to be attached to a band, place the band below both
                                  blades.
                                    For shirring or ruffling more than one inch from
                                               when on
                                             machine and remove the part with the under blade
                                               I attached. Now remove the front shuttle race

its place, mushing it in as far as it woogo ra bite rio slinthe heriar ido
withoutWhereonetry thof them.lie bit the o i led ten inter title i it the some time, nor to ruste
tween the steel blades,Neverbecauserunthethemovemmachinentwhenof thetheteethrufflerof theis onupperwithoutbladegoodsagainstbe-
the lower will dull them and soon make it teless.         Oil working parts before using.





              HOW TO USE THE TUCKER.
  The Tucker attaches the same as the ruffler. Loosen the adjusting screw Kand move
the gauge I to the desired width of tuck, as shown by scale M. For example set it at

 the figure 1; now move the marker until the pointer O is over figurel on its scale also.

The tucks will then be one-eighth of an in wide and just net. For space beliveen
the tucks, move the marker to the left as mich as the space desired.
              TUCKER.
                                THE HEMMERS 4 widths.   Attach
                                hemmer to attachment holder as above,
                                 and pass the goods into the scroll, being
                                       careful to draw it through the hemmer
                                as far as the needle hole that the feed
                                         may catch the cloth. Should too much
                                             goods run into the hemmer. carry to left.



                                                          cut binding is used if Should be  THE BINDER-Attach binder to holder as above.If
                                         Piss through binder and place goods betweenbias and seven eighths of an inch wide.

upper and lower scrolls.