Tamron Adapt-A-Matic Mount another User manual

INTERCHANGEABLE
   mmr6[,  W
       MOUNT

        flow To
              Install
            and
          Dismantle





To fix the mount frame O to the lens barrel, setthe mount side (Fies. 5 and 6), and fix it securel
a clockwise motion.

Turn the mount frame in a counter-clockwise motion over a range of abouti;m   untii ttre oositioning pin @ engages the cut-out @ on the rim of theiend-birrei, bresi the couiltine pin @ on tfre mount section manually..(Fie..4)anO check whether it funitions'smoothly. lf the aperture varies each time thecoupiing pin is depressed, the mount must be installed all over again.

To fix the mount frame O to the lens barrel,set the mount setting @ fromth1 moUnt siOe (Fies. 5 and 6), an.d  f ix it securely by turning it all the way in
a clockwise motio, n.                            www.butkus.us

-
 Procedure-       for dismantling To dismantle the TAMRON Adapt-A-Matic mount from the TAMRON ADAPT-A-MATIC  Fully Automatic Lens, follow the installing  procedure in reverse.
  First, remove the mount setting ririg @ and  disengage the positioning pin @ from the  cut-out @ by slightly pulling the mount frame in a clockwise motion over a range  of about I cm, remove the mount from the  lens barrel with due precaution against flex-
  ing the lever.
  In case of the TAMRON Adapt-A-Matic  mounts for Canon (C-AF) and Miranda (M-A)  cameras, the mount setting ring @ will not
 come apart from the mount frame O; there-  fore, make sure that it is loosened sufflcient-  ly before proceeding to dismantle the Uni-
  versal mount from the lens.
                            www.butkus.us