New Home Attachments — User manual

Ulustrated Directions

FOR USING

OUR LATEST SPECIAL SET

STEEL ATTACHMENTS

UPON: THE

New Home Machine.

HOW TO USE
THE RUFFLER

Remove the regular foot, and slip'the rufiler in
its place with the forks of the lever A (sce cut of
rufller on page 4) over the shank of thé needle
set-screw, and fasten securely. Place phe goods
to be ruffled between the steel blades F. To
make scant ruffling, move the adjusting lever B
from you, and shorten the stitch to the desired
length. The length of the stitch should match
the size of gather or plait so that they will lie
even and not pile upon each other or'be too far
apart. To make larger plaits: move the adjust-
ing lever B toward you; and: lengthen the stitch
to match. If the ruffle is to be attached to a
band, place the band below both blades,

For shirring or ruffling more than onoinch from
the edge of wide pears ytirh loosen the screw
D from the right hand side of the rufiler when on
the machine, and remove the part with the under
blade F attached. Now remove the front shuttle
race slide of the machine and slip the shirrin,
slide G in its place, pushing it in as far as it wilt
qo, and proceed to rufile ‘as instructed above.
When through put the blade F back again and
fasten with the screw D,

Never try to use both the slide G and under
blade F at the same time, nor to ruffle without
one of them, Never run the machine when the
tuffler is on without goods between the steel
blades, because the moyement of the h of the ~
upper blade against the lower will dull them and
soon gale it useless. Nbadt pos aeteue bale

eS ERE Ep sista © yh ara

i

Oil working parts lightly before using.