White Five-Stitch Attachment — Book 12 — User manual

To oi the two places under spool pin plate,
unscrew the spool pin and turn plate ay
around. After oiling turn plate back int

Under view of Rotary Head showing Oiltng Places.

Be sure to keep machine well oiled. To oil the
under side of machine, slip the belt off the hand
wheel, turn machine-head back on its hinges and
oil in all places shown above.

Good oil is an absolute necessity in the
smooth running of a sewing machine.

WHITE Sewing Machine Oil, especially pre-
pared, is a quality product that will satisfy
you in every particular.

INSTRUCTIONS

FOR USING THE

White Rotary Sewing Machine

‘The Treadle Movement

The treadle movement should be thoroughly
learned, so that you can readily revolve stand
wheel by pressure on treadle with both feet.

Remove belt from the wheel (see directions
below) and place your feet on the treadle directly
over the treadle support; take hold of stand wheel
and turn it from you, allowing the feet to move
freely with the motion thus commenced, and con-
tinue this by an alternate pressure of heet and
toe until a regular and easy motion is obtained.

‘Do not attempt to learn anything else until you
are proficient in the use of the treadle, so as to
be able to start and stop the staid wheel without
turning it in the wrong direction.

Directions For Removing Belt From Machine

To remove belt from head when machine is
‘open, raise the lid with the left hand as tho about
to close machine, which will lower head just
enough to give the belt free play. Then grasp
belt with right hand and slide it over the hand-
wheel from you